top of page
FastPatch 2.png

FastPatch Concrete & Asphalt Patch Repair

FastPatch Concrete & Asphalt Patch Repair is a fast, effective way to quickly repair holes in concrete and asphalt

Easily mixed and applied, simply add 3 parts powder to 1 part water and pour the material into the hole. It is suitable for internal and external applications and ready for vehicle traffic in just 2 hours! The fibre reinforced formula is stronger than standard concrete.

  • Simply add water, mix and pour

  • Stronger than concrete

  • Self levelling

  • Dries at temperatures as low as 5°C

  • Can be used on dry and damp surfaces

  • Can be feather edged to a depth of 120mm

  • Good slip resistance

  • Odourless and non toxic

  • Available in 10kg & 20kg sizes

Surface Preparation

The substrate should be clean and free from any sitting water. Heavily trafficked areas should ideally have edges cut to 10mm minimum.

 

Mixing

Remove the bag of powder from the container. The container makes an ideal mixing vessel. FastPatch is a simple 3 part powder to 1 part water mix. Always add the powder to the water (not the other way around) to make mixing easier and achieve a pourable mix. Due to the short application time, mix  the product as close to the repair as possible, small quantities can be mixed by hand with a wide bladed  tool. Large quantities are best mixed with an electric drill and mixing blade, always ensure you incorporate all the product from around the edges of the mixing container. Use immediately as the product will start to harden quite quickly. Application tools can be washed off with clean water straight after use. Remaining powder can be stored in a dry place and used at a later date.

 

Application

Once a smooth and lump free consistency is achieved, simply pour the FastPatch into the  hole. It will flow freely and require minimal trowelling. Application depths are between 5mm-100mm, although lightly trafficked areas can be feather edged.

bottom of page